Xerox 4635 - Manual (Page 114)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1967 CAUTION: ‘CONTINUE’ may cause job sheets to be stacked
on top of adjustment sheets.
You have entered the CONTINUE option with the PQA
command on a system with only one output tray (finisher). Note
that the sheets of paper for your job may be stacked on top of
the sheets used for print quality adjustment (PQA).
Action None.
OS1970 FEX exiting. Unable to run during a print job.
(4050/4090/4650 only) The LPS printer is actively running a print
job. Therefore, FEX cannot begin processing your test case job.
Action Ensure that the system is idle, then retry FCG.
or
OS1970 FCG exiting. Unable to run during a print job.
FCG verifies that neither the input nor output tasks are active
before beginning its activities. If either input or output is busy
processing data, FCG displays this message.
Action Ensure that the system is idle, then retry FCG.
OS1971 FCG exiting. FCG.Lib not present on the system.
The system cannot find the requested FCG.LIB file which contains
the FCG‘s personality profiles.
Action 1. Verify the .LIB name and retry the command.
2. If the message reappears, contact your supervisor or systems
specialist.
OS1972 FCG exiting: unable to locate: x.
Action 1. Verify the profile-name and retry the command.
2. If the message appears, contact your supervisor or systems
specialist.
OS1973 FCG exiting. Duplicate profile entries.
The system has found a personality profile-name with the same
name you have specified. This message is followed by message
OS1976 PROFILE NOT LOADED.
Action 1. Verify the profile-name and retry the command.
2. If you get the same message, contact your supervisor or
systems specialist.
OS1974 FCG exiting. Profile for <profile-name>successfully loaded.
FCG has successfully completed its tasks. For example, wire
management with FCG, profile-name would be the FCG WIRE
[parameters] command values you have entered.
Action None.
6-38 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE