Xerox 4635 - Manual (Page 116)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1982 FCG exiting. Invalid profile encountered.
(4050/4090/4650 only) The system cannot accept the parameters
or values you have entered. The cause may be incorrect syntax,
too many characters, etc. This message is followed by message
OS1976 PROFILE NOT LOADED.
Action 1. Verify that your values and/or syntax are correct and retry the
command.
2. If the message reappears, contact your supervisor or systems
specialist.
OS1983 FCG exiting. Failure to connect to the iot.
(4050/4090/4650 only) The FCG utility is unable to communicate
with the printer. There may be a print job or another system task
being processed.
Action 1. Retry the FCG command.
2. If the message reappears, look for other system or printer
messages to explain the condition.
3. If still unable to run FCG, contact your supervisor or systems
specialist.
OS1984 FCG exiting. Data value is out of range.
(4050/4090/4650 only) FCG has checked to see that all the data
values specified in your command are within allowable ranges
before updating the printer‘s non-volatile memory (NVM). Some
values you specified are out of range.
Note: The percentage of wire left on the spool parameter must
be between 0 and 100 percent. A value greater than 100, for
example, would be out of range.
Action None.
OS1990 Pre-format form - using system default paper size
The header of the specified form file lacks the proper edge mark
information which is needed by the system to determine paper
size. The system default paper size is used for the job.
Action None.
OS1991 No test patterns form available for specified source size
No test pattern form file is available for the paper size requested.
Action Select a different paper size and retry the command.
or
Abort the operation.
6-40 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE