Xerox 4635 - Manual (Page 183)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS8989 Unable to initiate output task.
The system is unable to begin the indicated procedure, due to a
fatal software error. (This message usually appears in conjunction
with another message explaining the nature of the error
condition.)
Action 1. Check the display for other relevant messages and follow
instructions given for it/them in this guide.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
OS8990 Unable to initiate output task.
The requested output task cannot be found or read from disk.
Action 1. Enter the RESET command.
2. Restart the job.
3. If the message reappears, reboot the system by pressing the
Boot button and entering B.
4. Restart the job.
5. If the problem continues, resysgen if authorized to do so
(refer to your 4635 LPS System Generation Guide),
or
Contact your systems specialist.
OS Level 9: Probable severe hardware error
Warns of probable hardware errors.
OS9050 Unexpected error detected by RIP. Enter:
A RIP error has occurred. You will be prompted to CONTINUE
or ABORT.
Action Enter CONTINUE or ABORT as appropriate.
OS9101 Unable to access; RECTK$SYS.
Either RECTK$SYS does not exist or a read error was detected.
Either condition causes job recovery to fail and the job is
aborted.
Action 1. If RECTK$SYS does not exist, DSR restore, sysgen, if
authorized to do so, or contact your systems specialist to
recover RECTK$SYS.
2. If RECTK$SYS does exist:
a. Contact your systems specialist or Xerox Customer
Support to log the bad sector and delete RECTK$SYS.
b. Restore the file via a DSR restore, resysgen, if authorized
to do so, or contact your systems specialist.
c. Resend the job.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-107