Xerox 4635 - Manual (Page 151)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS4990 System reliability log data being lost. Use “PROBLEM”
The disk-resident system error log is full. Output can be
resumed, but errors will no longer be logged.
The printer control console displays:
OUTPUT STOPPED--SEE MESSAGE AT CRT
Action 1. Enter the PROBLEM command to obtain the SAN code
numbers.
2. Contact your systems specialist or Xerox Customer Service.
Note: CRT refers to the 4635 LPS system controller display.
OS4995 Use problem at earliest opportunity.
The system Error Log is nearly full.
Action Use the PROBLEM command to avoid loss of error log
information. (Refer to the problem solving chapter in your 4635
LPS Operator Guide.)
OS Level 6: Job integrity
Identifies possible errors affecting output and what action(s), if
any, to take.
OS6000 Insufficient memory for ‘ACCTINFO’; Continue or Abort?
JSL specified the ‘ACCTINFO’ option of the RSTACK command.
There is not enough dynamic memory for it.
Action 1. Enter the CONTINUE command, or press the key
to print the job without delimiter sheets.
or
Enter the ABORT job command to cancel the job.
2. Recreate the job, reducing the number of features.
OS6005 Invalid Ethernet tape preamble format.
Information in the Ethernet tape header (preamble) is missing or
incorrectly formatted. Job will not print.
Action Recreate the job tape, ensuring that the data is formatted
correctly. (Refer to Xerox 4635 LPS Tape Formats Manual.)
OS6006 Invalid Ethernet print procedure message.
The Ethernet tape contains an incorrect sequence of bytes
describing procedures for printing. The job will not print.
Action Recreate the tape, ensuring that the print procedures information
is formatted correctly. (Refer to Xerox 4635 LPS Tape Formats
Manual.)
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-75