Xerox 4635 - Manual (Page 103)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1500 Page spacing stopped by Beginning-of-Report
The SPACE -n PAGES command was entered, but the system will
not space backward any more because it sensed a magnetic tape
label indicating the beginning of a report.
Action None.
OS1509 Page spacing already in progress
The SPACE n PAGES command was entered, but the system had
not completed a previously entered spacing command.
Action None.
OS1510 Page spacing stopped by End-of-Report
The SPACE n PAGES command was entered. The system cannot
space forward any more because it sensed a tape label indicating
the end of the report.
Action None.
OS1520 Block spacing stopped by End-of-File
The MOVE n BLOCKS command was entered, but the system has
reached the End of File tape label and cannot move forward over
any more text.
Action None.
OS1530 Cannot backward space any more pages
The SPACE -n PAGES command was entered. The system cannot
space backward any more pages because it is printing the last or
only copy of a report. (Pages were cleared from system disk
immediately after printing.)
Action None.
OS1535 Formatting WP Exception index page
Exception Page is being created, indicating errors in report being
sent from workstation. Page will be delivered as last page of
report.
Action 1. Check Exception Page for location of errors in report.
2. Remake job if desired.
OS1540 Cannot space past start of job
One of the following commands was entered:
MOVE n BLOCKS
MOVE n FILES
SPACE n PAGES
SPACE n REPORTS
The system has reached the beginning of a job and cannot space
backward any farther.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-27