Xerox 4635 - Manual (Page 133)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS2681 Print Quality Adjustment is required.
The black housing is not ready.
Action Perform a print quality adjustment (PQA) before using the black
housing for printing.
OS2682 Change housing for printing in requested ink.
The printer requires a primary color which is not currently loaded.
Action Change the color housing for the requested ink
or
Abort the print job.
OS2683 Change housing for color printing or
This message is displayed when a problem occurs with the
current color housing. It is followed by these messages: OS2673
ENTER THE SUB INK COMMAND OR ABORT THE PRINT JOB and
OS2000 ENTER ‘CONTINUE O’ TO RESUME PRINTING.
Action None.
OS2690 Ensure proper stock is loaded and output tray is empty
In response to a PQA command, this message reminds you to
make sure of the following:
• The stock you want to use for the print quality adjustment
(PQA) is loaded in the paper tray
• The target PQA output tray is empty.
Action None.
OS2691 Ensure proper stock is loaded for Print Job
This message appears after print quality adjustment is completed
when STOP was specified in the PQA command, or if you have
pressed the Stop button or entered PQA CANCEL.
Note: Be aware that if you enter the PQA CANCEL command,
the housing on which PQA was being performed will not be
ready.
Action Make sure the job stock is loaded.
OS2692 Empty output tray
For a two output tray system, the selected output tray must be
empty in order for print quality adjustment to start. This message
appears after print quality adjustment is completed when STOP
was specified in the PQA command.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-57