Xerox 4635 - Manual (Page 170)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS6920 LINE exceeded page limit. Line truncated.
A new margin has taken effect or a new line was started. Current
line length is longer than page size. The excess has been cut off.
Action 1. Check the JDL/DJDE MARGIN commands and change the
margin size.
2. Ensure that the correct paper size was specified at sysgen.
3. If the problem recurs, recreate the job, changing line length,
font size, and/or carriage returns.
OS6949 Page density exceeded, page won‘t be printed. ABORT O or.
The page being imaged has too many characters per line. The
page will not print. (Message is followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Enter the CONTINUE O command to resume printing if data
loss is acceptable.
or
Enter the ABORT O command to cancel the job.
2. Recreate the job, reducing the amount of overprinting and/or
shading.
OS6950 LINE density exceeded, page won‘t be printed. ABORT O or.
The page being imaged has too many characters per line. The
page will not print. (Message is followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Enter the CONTINUE O command to resume printing if data
loss is acceptable.
or
Enter the ABORT O command to cancel the job.
2. Recreate the job, reducing the amount of overprinting and/or
shading.
OS6951 Unable to rasterize local density problem page.
An imaging error occurred while attempting to rasterize a page
with a local density problem. The page cannot be rasterized; i.e.,
a bitmap image of the page cannot be produced.
Action None.
OS6952 Imaging error. Possible data off page. Page integrity cannot
be guaranteed, therefore page will not be printed.
An imaging error has occurred on the current page.
Action 1. Press the key to continue printing.
2. Check output. If data is imaged off page, recreate the job,
redistributing print data.
6-94 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE