Xerox 4635 - Manual (Page 197)

PDL (JOB SOURCE LIBRARY COMPILATION) MESSAGES
PD8570 Device does not exist %0.
The specified device does not exist. Check command and retry.
Action None.
PD8800 Insufficient dynamic memory, try rebooting system.
Not enough core memory remains for the entered command.
Compiling will abort.
Action 1. Reboot the system by pressing the Boot button and entering
B at the keyboard.
2. Retry compiling JDL.
3. If the message reappears, contact your systems specialist or
Xerox Customer Service.
PD9400-PD9480 Disk error —xxx file.
The system is unable to access or perform any operation on the
indicated file because of a fatal system disk error.
Action 1. Retry the command. This message should not reappear if the
failure was an intermittent system disk error.
2. If the message reappears, contact your systems specialist or
Xerox Customer Service.
PD9400 DISK ERROR—JDL FILE
PD9410 DISK ERROR—WORK FILE
PD9420 DISK ERROR—SOURCE FILE
PD9430 DISK ERROR—CME FILE
PD9440 DISK ERROR—PDE FILE
PD9450 DISK ERROR—PRINT FILE
PD9460 DISK ERROR—PCC TABLE
PD9470 DISK ERROR—CATALOG FILE
PD9480 DISK ERROR—RTEXT FILE
PD9500 Open error —Print File.
The system is unable to open the print file due to a system disk
error.
Action 1. Retry compiling.
2. If the message reappears, contact your systems specialist or
Xerox Customer Service.
PD9510 PDL restart error opening Save File.
At termination of PDL processing, an attempt to save the file was
unsuccessful due to a system disk error.
Action 1. Recompile JDL and retry.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 7-5