Xerox 4635 - Manual (Page 140)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS2921 Check finishing parameter NVM memory
The printer‘s finishing information may have incorrect non-volatile
data.
Action Restore the values that were displayed at the printer control
console.
OS2922 Enter the TOTAL number of sets to create:
This is one of a series of prompts for information to develop the
FEX test case. This message is followed by messages OS2923,
OS2924, OS2008, and OS1136.
Action Enter the number of sets you want printed for the FEX test job.
OS2923 Enter the number of pages per set:
This is one of a series of commands which asks you for
information to develop the FEX test case. Related messages are
OS2922, OS2924, OS2008, and OS1136.
Action Enter the number of pages for each set of the FEX test case job.
OS2924 Enter the FRM name (leave off the .FRM)
This is one of a series of prompts for information to develop the
FEX test case. Related messages are OS2922, OS2923, OS2008,
and OS1136.
Action Enter the form name (without the directory or file-type name)
you wish to use for the FEX test job.
OS2950 Software timing problem has caused a printer cycle-down
Input is being processed too rapidly for output to print. Output
has stopped.
Action Enter the CONTINUE O command to resume printing.
OS2960 Back up host to start of report or nn pages, whichever is less
The system is in a recovery mode after a software failure.
Action Resend either the number of pages stated or the entire report
that was printing at the time of the failure.
OS2980 Function not available in this LOGON class
The usage of the entered command was restricted at installation
by an RCU (Restrict Command Usage) command.
Action Obtain the correct password and log on at the required level.
(Refer to your 4635 LPS Operations Reference chapter on setting
LPS parameters for additional information.)
6-64 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE