Xerox 4635 - Manual (Page 270)

4635 LPS ADDITIONAL MESSAGES
Cannot use Reserved Words in file names.
The words CON, CLOCK$, AUX, COM(1-4), LPT(1-4), NUL, and
PRN are recognized by the PC User Interface as DOS commands
and therefore cannot be used in file names.
Action Rename any file that has these terms in the file name.
Client-Layer is established
The 4635 LPS is communicating normally.
Action Before printing, check the PC user interface or printer control
console for instructions on clearing any existing faults. If you are
instructed to select CLEAR, you can either select the Clear Faults
button on the PC user interface screen, or enter CLE in the
command line message window.
Command sequence error, FGRP_HEADER not 1st.
The first group of report definitions must define the header;
other records were encountered.
Action If the problem persists, call Xerox Customer Service.
Command sequence error, group not larger than last.
At least one of the report definition groups is out of order.
Action If the problem persists, call Xerox Customer Service.
Command sequence error, number out of range.
Numeric parameter for a report definition command is out of
range.
Action If the problem persists, call Xerox Customer Service.
Command sequence error, record number not equal to last
+1.
One or more of the report definition commands are out of
order.
Action If the problem persists, call Xerox Customer Service.
Communication with the Printer is established
Low-level communication between the system controller and the
printer has been established. The system will now attempt to
initialize Client-Layer communication.
Completed reports not finished transfering from In-Process
Log.
Exit to DOS has been erroneously enabled and selected. No loss
of data should occur as the transfer process will continue when
the PC UI session is restarted.
Action If the problem persists, call Xerox Customer Service.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 15-27