Xerox 4635 - Manual (Page 90)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1103 FEX: Error, problem while restoring IOT Memory.
A serious error has occurred when FEX attempted to
communicate with the printer.
Action Restart FEX.
OS1104 Failed to connect to the IOT. Exiting.
FEX could not establish communications with the printer,
because a job is printing.
Action Restart FEX when the 4635 LPS is not actively printing a job.
OS1105 No valid machine serial number received. Task exiting
The printer serial number was not found when the system
attempted to produce a billing report.
Action If authorized to do so, resysgen the system, entering the serial
number (located on a panel inside the printer) when instructions
on the display ask for it. (Refer to 4635 LPS System Generation
Guide, or contact your systems specialist.)
OS1106 Lowercase characters not valid in machine serial number
Lowercase characters are not valid in the machine serial number.
Action 1. Verify the tray(s) or bin(s) in your command.
or
Select a different tray or bin.
2. Retry the command.
OS1131 FEX: Problem communicating with the IOT. Exiting.
FEX has detected a problem communicating with the printer.
Action Restart FEX.
OS1132 --- NVM Finishing locations ---
This message lists the values that are currently in the printer‘s
non-volatile memory.
Action Save (write down) these values so that you can restore them
should an FEX communications problem lose these values from
the printer‘s non-volatile memory.
OS1133 FEX: Warning, number of pages is greater than 23.
This message advises you that you have selected too many pages
for the FEX test print job.
Action 1. Select fewer pages for the test case job.
2. Retry running FEX.
Note: This may be an issue only with certain finishing devices
which require readjustments for page sets of more than 23
pages. Consult your finishing device documentation for
additional information.
6-14 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE