Xerox 4635 User Manual
Page 126
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS2290
Enter ‘RETURN’ to continue cluster display
The cluster list contains more than a single display of information.
Action
Press the
displays.
OS2291
Response timeout - cluster display stopped
The CLUSTER or CLP command was used to display the cluster
list but the
amount of time to continue the cluster display. The cluster
display has been terminated.
Action
Reenter the CLUSTER or CLP command, if desired.
OS2295
Problem with stockset, see display below
One or more clusters in the current stockset has a problem. A
cluster display follows, indicating specific errors that should be
resolved before printing. If a status is flashing, it must be
resolved before you can print.
Action
1. Correct the problem shown flashing in the status column.
2. Press the
OS2296
Log printing not allowed until system status='Idle'
The system must be offline and not printing to process a log
print request.
Action
Complete or abort any current jobs, enter the OFFLINE command
and then resubmit the log print request.
OS2310
Bin x not ready
For a system with one or two output tray(s), the selected output
tray is not ready to begin processing print jobs.
This message may be displayed after you have entered
‘CONTINUE O’. This message is followed by OS2000 ENTER
‘CONTINUE O’ TO RESUME PRINTING, if printing is ready to
begin.
Action
None.
OS2320
Bin 2 not ready
The selected output tray must be ready in order for print quality
adjustment to start. If not, this message is displayed after you
have entered the CONTINUE O command. This message is
followed by OS2000 ENTER ‘CONTINUE O’ TO RESUME
PRINTING.
Action
None.
6-50
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE