Xerox 4635 - Manual (Page 129)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS2556 Out of fuser lubricant. Add two tubes of fuser lubricant.
There is no fuser lubricant remaining in the system.
Action Add two tubes of fuser lubricant if authorized to do so, or
contact your supervisor.
OS2560 Please clean the tape drive before next tape mount.
Clean the magnetic tape drive before mounting the next tape
drive. (Refer to the maintenance chapter in your 4635 LPS
Operator Guide.)
Action None.
OS2570 VAry system offline at the host and enter ‘CONTINUE I’
or
Vary system offline at the host and select ‘CONTINUE I’
The OFFLINE command was entered.
Action 1. Follow procedures required to take the printer offline at your
host system.
2. Enter the CONTINUE I command.
OS2576 System rollover while online. CHeck host then enter ‘C’
or
System rollover while online. Check host then select or
enter ‘C’
A software failure has occurred while the system is online. A
rollover has taken the system offline.
Action 1. Follow procedures required to take the printer offline at your
host system.
2. Enter C to initiate the automatic recovery procedure.
3. Follow recovery instructions on the display. (Refer to the
online chapter in your 4635 LPS Operator Guide.)
4. After the recovery procedure is complete, resend any lost
data and enter the CONTINUE O command to resume
printing.
5. If a software failure recurs, contact your systems specialist or
Xerox Customer Service.
OS2600 Tape volume out of sequence; mount correct volume
Magnetic tape label number detected by sensors does not follow
previous volume number.
Action Remove tape and mount volume that is next in numerical order.
(Refer to your 4635 LPS Tape Formats Manual.)
OS2610 Improper ink-name list specification
The ink-name list you have specifed does not conform to ink-
name list syntax. For example, you may have used double
instead of single quotes to identify the ink-names.
Action Check the specifed ink-names and retry the job.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-53