Xerox 4635 - Manual (Page 127)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS2341 Printing can be resumed using standard page recovery,
%n%+ or the entire finishing set can be reprinted, %n%+
Enter: “P” for standard page recovery %n%+ “S” to reprint
the entire set %n.
A jam has occurred during a report with SRECOVERY=ASK in
effect.
Action Select the desired recovery option.
OS2342 Reprinting of the entire finishing set required %n%+.
Discard incomplete set from the finisher.
Segment recovery is in effect. Follow clearance instructions, then
press CONTINUE.
Action None.
OS2350 STiming value ignored. Use FCG to set device parameters.
An STIMING command has been detected in the datastream.
This command is ignored because the printer relies on the
operator using FCG to specify finishing-device timing parameters.
This message is informational only.
Action None.
OS2400 Printer misfeed detected. Check paper supply.
Paper was improperly fed from the main and/or auxiliary feeder
tray, causing a jam condition.
Action Release the feeder belt and check both feeder trays, removing
any misfed paper. (Refer to the problem solving chapter in your
4635 LPS Operator Guide.
OS2451 Requested bypass not on system. “CONT” defaults to bin.
Enter Continue or Abort.
A job with DESTINATION=EXPORT is being run on a printer with
no Bypass Transport. Press CONTINUE to resume input
processing, or abort the job if desired.
Action None.
OS2452 Problem with segment separator save file.
A problem has been encountered while accessing the separator
page save file.
Action None.
OS2453 Invalid font index number for printable string.
The font index specified for the SNUMBER string on a separator
page is invalid. Correct and rerun job.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-51