Xerox 4635 - Manual (Page 16)

DSR (DISK SAVE AND RESTORE COMMAND) MESSAGES
DS8010 Tape error xxxx...DSR aborted
The system has encountered a device error from which it was
unable to recover after several attempts. DSR task is aborted.
Action 1. Clean the tape drive and retry the task. (Refer to the
maintenance chapter in your 4635 LPS operator guide.)
2. If the problem continues, replace the save tape.
DS8020 Tape is read only...DSR aborted
The tape is designed to be read but not written. Data cannot be
copied onto it. The DSR task is aborting.
Action Use a different tape.
DS8030 Tape is write protected
The save tape does not have a write enable ring. Data cannot be
copied onto it. The DSR task will abort.
Action 1. Add a write enable ring to tape.
2. Reenter the DSR command.
DS8040 6250 not supported, defaulting to 1600
The DSR 6250 command was entered, but your system does not
support a recording density of 6250 bpi. The system will record
at 1600 bpi.
Action None.
DS9010 Disk error xxxx...DSR aborted
The system has encountered an error on disk from which it was
unable to recover after several attempts. The DSR task is
aborted.
Action Contact your systems specialist or Xerox Customer Service.
DS9020 DSR aborted
The DSR task has aborted due to a hardware error.
Action 1. Retry the DSR task.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
DS9030 File structure integrity error...DSR aborted
This message occurs during the DSR process of saving disk files
to tape. Either multiple-allocated or nonallocated blocks have
been encountered. The DSR process has been cancelled.
Action 1. Enter the COMPRESS command.
2. If the compress procedure fails, reformat the disk. (Refer to
your 4635 LPS Operations Reference.)
2-2 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE