Xerox 6204 EN - Manual (Page 95)

8 Special Feature Keys
Wide Format Copy System User Guide 89
3. Press the Sample key again to disable the Sample feature. The Printer is returned to
the default priority setting and the Sample and Printer Interrupt indicator lamps are
extinguished.
Scan Mode Sample
The best sample prints will be produced if the image enhancement features have been enabled.
Refer to the Image Quality section of this document for more information.
In order to have the selections indicated below in the SAMPLE MODE screen, the Scan-to-Net
feature key must be installed to get SCAN IMAGE TO FILE, and the Scan-to-Print feature key
must be installed to get SCAN IMAGE TO PRINTER. It is convenient on the Wide Format Copy
Systems to be able to make a sample before scanning an image to file.
To print a sample copy, perform the following:
1. If the Scan System is set to COPY mode, switch to SCAN mode. For more
information, refer to the section of this document entitled “Switching between COPY
and SCAN mode”.
2. Enter the Directory name.
3. Press the Sample special function key. The SAMPLE MODE screen is displayed.
SAMPLE MODE
FILE: LOCAL FILE
SCAN IMAGE TO PRINTER
9
Sample Mode Screen 2
NOTE: When there is no Scan-to-Print license present, the FILE field will not be shown. Instead,
it will be replaced by the phrase "NO SCAN-TO-NET LICENSE".
The FILE field has the following options to choose from:
LOCAL FILE - Creates a local file on the hard drive.
DESTINATION 1 – 16 - Either an FTP or remote printer destination, configured via Web
Printer Management Tool "Configuration Scanner" page.
NOTE: At least one destination must be specified for a file. If you select NO FILE and disable the
SCAN IMAGE TO PRINTER checkbox, then you will not be able to exit the screen until
either the Scan-to-Print checkbox is selected, or a destination other than NO FILE is
selected.
4. Press the Next key to highlight SCAN IMAGE TO PRINTER.
NOTE: When there is no Scan-to-Print license present, the SCAN IMAGE TO PRINTER
selection field will not be shown. Instead, it will be replaced by the phrase "NO SCAN-
TO-PRINT LICENSE".
5. Press the Enter key to enable SCAN IMAGE TO PRINTER. Press the Exit key to
exit the menu. The processing time for Scan-to-Printer images will be longer,
depending on the image size.