Xerox 6204 EN - Manual (Page 36)

2 Getting to know the Wide Format Copy System
30 Wide Format Copy System User Guide
The Printer and the FreeFlow Accxes Controller
For detailed operating instructions about the Printer and Controller components of the Wide
Format Copy System and about network connectivity, refer to the documentation listed below.
y FreeFlow Accxes System & Web Printer Management Tool Setup Guide
y FreeFlow Accxes Controller Service Manual for HFT/PUN
y Xerox FreeFlow Accxes Controller Service Manual for YKE/
YKE-N/FRX/LVX
Powering On the Wide Format Copy System
To power on the XEROX Wide Format Copy Systems, you first must switch on the Scan System
and wait for 30 seconds or check that a “P” is displayed on the status LED in the back of the Scan
System. Then switch on the Printer, then the Controller.
Follow the instructions provided in this section for your system.
Initial Power-On
For all controllers except the YKE, YKE-N, FRX and LVX controller, when the Wide Format Scan
System is present, the DDS parameter must be set to Enabled in order to enable the
COPY/SCAN functionality of the scanner. Go to the Web Printer Management Tool. Select
Configuration > Printer > Printer Setup > DDS Enabled. Be sure that the DDS Enabled checkbox
is selected. If the DDS Enabled checkbox is not selected, then the COPY/SCAN functionality will
be disabled.
The default for this parameter is disabled. You must ensure that it is set to Enabled when
powering on the Xerox Wide Format SCAN SYSTEM for the first time. After setting the DDS
parameter, wait 30 seconds, and then power the system off then on. Once you enable this
parameter, it will remain enabled (even following future software upgrades).
For the Xerox Wide Format Copy System 510 Series, you can set this parameter from either the
CONTROLLER CONFIGURATION screen of the Printer Control Panel or on the Web Printer
Management Tool. For the Xerox Wide Format Copy System 6030/6050/6050A, 721P, 6204,
and 6279 you can only set this parameter from the Web Printer Management Tool, (Configuration
> Printer > Printer Setup > DDS Enabled).