Xerox 6204 EN - Manual (Page 37)

2 Getting to know the Wide Format Copy System
Wide Format Copy System User Guide 31
Switching on the Scan System
To switch on the Scan System, press the Power On/Off Switch on the back of the Scan System to
the On (I) position as shown below. Wait for 30 seconds or until a P is displayed on the status
LED.
Power Switch for the Scan System
When the Scan System is switched on, the fluorescent lamp inside the Scan System illuminates
immediately. If the lamp does not illuminate, refer to the "Problem solving" section of this guide.
Switching on the PUN, YKE or LVX Controller and the Printer (Xerox Wide Format
510 Series/721P)
Controller Power Switches
The YKE, PUN, and LVX Controller have their own power switch. First power on the Controller,
and then power on the Printer.
SCAN SYSTEM
Power Switch
YKE and LVX Controller
Power Switch