Xerox 6204 EN - Manual (Page 158)

13 Problem Solving
152 Wide Format Copy System User Guide
Problem First solution to try Second solution to try Third solution to
try
Vertical lines and streaks are
visible in the copy. Clean the Platen Glass.
Visible document edges on
the copy. Try a lighter Contrast setting.
ark spots or smudges appear
on the copy. Clean the Platen Glass. Inspect the original and
clean it if necessary. Adjust the Copy
setting for best
image quality.
The copy image is too light. Adjust the Copy setting for
best image quality. Rotate the original 90
degrees.
The image density on the
copy varies from light to dark. Rotate the original 90
degrees. Adjust the Copy setting for
best image quality.
Copies made in Photo mode
have geometric patterns. Set the Original, Type to
Normal and the Background
Suppression to Off. Set Original, Type to Line
and Background
Suppression off. Try a lighter
Contrast setting.
Fine lines on the original do
not appear on the copy when
the image size is reduced. Enable the LINE MODE LINE
PRESERVATION option. See
"Imaging" in the "Main Menu"
section for more information. Adjust the Copy setting for
best image quality.
Gray areas appear in the copy
at the location of creases or
folds in the original document. Refold the document in the
reverse direction to flatten the
creases or folds.
Error messages
An error message is displayed
on the Scan System Control
Panel. Locate the message in Table
8, "Error Code Messages," in
this section and perform the
corrective action indicated.