Xerox 6204 EN - Manual (Page 9)

1 Safety Notes
Wide Format Copy System User Guide 3
Disconnect Device
The power cable is the disconnect device for this equipment. It is attached to the back of the
machine as a plug-in device. To remove all electrical power from the equipment, disconnect the
power cable from the electrical outlet.
Operational Safety Information
To ensure the continued safe operation of your Xerox/Fuji Xerox equipment, follow these safety
guidelines at all times.
Do These:
- Always connect equipment to a correctly grounded power outlet. If in doubt, have the outlet
checked by a qualified electrician.
- This equipment must be connected to a protective grounded circuit.
This equipment is supplied with a plug that has a protective grounding pin. This plug will only
fit into a grounded electrical outlet. This is a safety feature. To avoid risk of electric shock,
contact your electrician to replace the electrical outlet if you are unable to insert the plug into
it. Never use a plug that lacks a grounded connection terminal to connect the product to an
electrical outlet.
- Always follow all warnings and instructions that are marked on or supplied with the
equipment.
- Always exercise care when moving or relocating equipment. Please contact your local
Xerox/Fuji Xerox Service Department or your local support organization to arrange relocation
of the product to a location outside your building.
- Always locate the equipment in an area that has adequate ventilation and room for servicing.
See the Install guide for minimum dimensions.
- Always use materials and supplies specifically designed for your Xerox/Fuji Xerox equipment.
Use of unsuitable materials may result in poor performance.
- Always unplug this equipment from the electrical outlet before cleaning.
Do Not Do These:
-
Never use a plug that lacks a grounded connection terminal to connect the product to an
electrical outlet.
- Never attempt any maintenance function that is not specifically described in this
documentation.
- This equipment should not be placed in a built-in installation unless proper ventilation is
provided. Please contact your Authorized Local Dealer for further information.
- Never remove covers or guards that are fastened with screws. There are no operator
serviceable areas within these covers.
- Never locate the equipment
near a radiator or any other heat source.
- Never push objects of any kind into the ventilation openings.
- Never override or “cheat” any of the electrical or mechanical interlock devices.
- Never operate the equipment if you notice unusual noises or odors. Disconnect the power
cord from the electrical outlet and contact your local Xerox/Fuji Xerox Service Representative
or Service Provider immediately.