Xerox 6204 EN - Manual (Page 10)

1 Safety Notes
4 Wide Format Copy System User Guide
Maintenance Information
Do not attempt any maintenance procedure that is not specifically described in the documentation
that is supplied with your copier/printer.
- Do not use aerosol cleaners. The use of cleaners that are not approved may cause poor
performance of the equipment, and could create a dangerous condition.
- Use supplies and cleaning materials only as directed in this manual. Keep all of these
materials out of the reach of children.
- Do not remove covers or guards that are fastened with screws. There are no parts behind
these covers that you can maintain or service.
- Do not perform any maintenance procedures unless you have been trained to do them by an
Authorized Local Dealer or unless a procedure is specifically described in the user manuals.
Ozone Safety Information
This product will produce ozone during normal operation. The ozone produced is heavier than air
and is dependent on copy volume. Providing the correct environmental parameters as specified
in the Xerox installation procedure will ensure that the concentration levels meet safe limits.
If you need additional information about ozone, please request the Xerox publication Ozone by
calling 1-800-828-6571 in the United States and Canada. In other markets please contact your
Authorized Local Dealer or Service Provider.
For Consumables
Store all consumables in accordance with the instructions given on the package or container.
• Keep all consumables away from the reach of children.
• Never throw toner, toner cartridges, or toner containers into an open flame
Radio Frequency Emissions
United States, Canada, Europe, Australia/New Zealand:
NOTE: This equipment has been tested and found to comply with the limits for a class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case users will be required to correct the interference at their own expense.
Changes and modifications to this equipment not specifically approved by Xerox/Fuji Xerox may
void the user’s authority to operate this equipment.
Shielded interface cables must be used with this equipment to maintain compliance with FCC
regulations in the United States and the Radio Communications Act 1992 in Australia/New
Zealand as applicable.