Calibration motor: off, Function: rotate – Xerox 6204 EN User Manual
Page 144
10 Main Menu
138
Wide Format Copy System User Guide
8. Press
the
Next
key until CALIBRATION MOTOR is highlighted.
9. Press
the
Enter
key to select CALIBRATION MOTOR. The CALIBRATION MOTOR
screen is displayed.
CALIBRATION
MOTOR: OFF
FUNCTION: ROTATE
Calibration Screen
10. Press the Previous or Next key to select FUNCTION.
11. Press the Enter key to select FUNCTION.
12. Press the Previous or Next key to highlight the desired function. The choices are
GO TO WIDTH, GO TO CALIBRATE, GO TO HOME, FIND HOME, and ROTATE.
13. Press the Enter key to confirm your selection.
14. Press the Previous or Next key to highlight MOTOR.
15. Press the Enter key to confirm your selection.
16. Press the Previous or Next key to highlight ON. The choices are ON and OFF. The
requested operation will execute.
If a GO TO or FIND function has been selected, the MOTOR field will be
automatically set to OFF when the MOTOR field is once again selected. If the
ROTATE function has been selected, the motor will run continuously until you set the
MOTOR field to OFF.
NOTE: If the Scan System encounters a failure accessing the calibration motor function, the
fourth line of the display will read "FAILURE CODE:" followed by a two-digit hexadecimal
number. The fourth line may also display NO RESPONSE FROM SCANNER if the Scan
System does not respond to the test request.
17. Press the Exit key to return to the Component Tests menu screen.
Read NVR
The READ NVR option allows the examination of the contents of the non-volatile RAM (NVR).
The service center may ask you to provide this information when calling for service.
To run the READ NVR diagnostic:
1. Press
the
Menu
key. The MAIN MENU screen is displayed.
2. Press
the
Next
key until DIAGNOSTICS is highlighted.
3. Press
the
Enter
key to select DIAGNOSTICS. The DIAGNOSTICS menu screen is
displayed.
4. Press
the
Next
key until SCANNER DIAGNOSTICS is displayed.
5. Press
the
Enter
key to select SCANNER DIAGNOSTICS. The SCANNER
DIAGNOSTICS menu screen is displayed.
6. Press
the
Next
key until READ NVR is highlighted.