Toshiba e-Studio Imaging 6520c - Manual (Page 87)

e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-53
2. Copier-specific Adjustments
(4) Enter adjustment mode [05]. Change the values for codes [1779], [1780], [1784], [1785], [1789], [1790],
[1794], [1795] or [7980] to [7983] to adjust the density level of each color.
Color to
adjust
Original mode [05] code Subcode
Recommended
value
Accep
table
value
range
Default
Text/Photo 05-1779 0/1/2
Text 05-1780 0/1/2
Y
(Yellow)
User custom 05-7980 0/1/2
Text/Photo 05-1784 0/1/2
Text 05-1785 0/1/2
M
(Magenta)
User custom 05-7981 0/1/2
Text/Photo 05-1789 0/1/2
Text 05-1790
C
(Cyan)
User custom 05-7982 0/1/2
Text/Photo 05-1794 0/1/2
Text 05-1795
K
(Black)
User custom 05-7983 0/1/2
Set a value larger than
128.
0 to
255
128
* Set the value in increments of approximately 10, while checking the copy image until the optimum value
is obtained.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode Area where the density is adjusted
0 Low-density area
1 Medium-density area
2 High-density area
‰ Caution after the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the copy. Also,
it may also cause offset failure, grained images and degradation in gradation. Therefore, carefully perform the
adjustment, while checking the copy image.