Toshiba e-Studio Imaging 6520c - Manual (Page 213)

e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
3-93
3. Printer-specific Adjustments
‰ Procedures
* The service technician must perform all adjustments.
* This adjustment will have an effect only on Auto or Color mode printing.
(1) Enter adjustment mode [05]. Decrease the values for codes [8070/8071] or [8089/8090] to reduce the limit
value of the maximum amount of toner used.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type and Halftone).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Resolution Halftone [05] code Subcode
Recommended
value
Acceptable
value range
Default
Smooth 05-8071 0/1/2/3/4/5/6/7/8/9
600dpi
Detail 05-8070 0/1/2/3/4/5/6/7/8/9
Set a value smaller
than the default.
0 to 255 128
Smooth 05-8090 0/1/2/3/4/5/6/7/8/9
1200dpi
Detail 05-8089 0/1/2/3/4/5/6/7/8/9
Set a value smaller
than the default.
0 to 255 128
* Set the value in increments of approximately 30, while checking the printouts until the optimum value is
obtained.
Subcode Paper type
0 Plain paper 1
1 Plain paper 2
2 Recycled paper
3 Thick 1
4 Thick 2
5 Thick 3
6 Thick 4
7 Special 1
8 Special 2
9 OHP
‰ Caution after the adjustment
The adjustment may possibly cause dark areas such as shades on photo images to look unnaturally faint.
Therefore, carefully perform the adjustment, while checking the printouts.
PCL6 PS3 Mac XPS