Toshiba e-Studio Imaging 6520c - Manual (Page 106)

e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-72
2. Copier-specific Adjustments
(2) Enter the adjustment mode [05]. Change the values for codes [7025], [7064] to [7065] or [7675] to adjust
the reproducibility of the background when using the RADF.
Color mode [05] code Recommended value
Acceptabl
e value
range
Default
Black 05-7025
ACS / Black 05-7675
Full Color 05-7764
Monocolor 05-7765
Twin Color 05-7766
Set a value smaller than 128
to increase the density level
of the background.
Set a value larger than 128 to
decrease the density level of
the background.
0 to 255 128
* Set the value in increments of approximately 20, while checking the copy image until the optimum value is
obtained.
‰ Caution after the adjustment
Correctly adjusting the installation heights of the MFP and the RADF is a prerequisite to perform this adjustment.
Therefore, perform all the necessary adjustments. Only if further adjustment is still desired for the reproducibility of
background, should this adjustment be performed.