Toshiba e-Studio Imaging 6520c - Manual (Page 18)

e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
1-8
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Automatic calibration
In paper types whose density has been adjusted, automatic calibration is performed for
all MFP modes in the following table. However, automatic calibration for each paper
type can be performed separately by changing the value of 08-9059 from "0" (default) to
"1". Automatic calibration only for paper types whose density has been adjusted can also
be performed; however, it is recommended to perform it for other paper types as well.
MFP mode How to perform automatic calibration
Copy
Perform step (1) referring to "2.13 To Obtain a Good Color Balance on
Thick Paper". Perform step (2) and later if required.
Print
(600dpi)
Print
(1200dpi)
Perform step (2) referring to "3.2 To Maintain a Steady Color Balance on
Thick Paper or Special Paper".
After automatic calibration, perform printing and check the image quality.
If further image quality adjustments are necessary, perform the next step.
(3) Check the life of the consumables (particularly the drum and transfer belt unit) and replace them, if
necessary.
• When replacing any consumable, use steps (a) to (b).
(a) Enter the PM support mode. Reset the counter corresponding to the replaced consumable to "0."
* For further information regarding the PM support mode, refer to the Service Manual.
Be sure to reset the counter. Otherwise, it may cause a loss in performance, including degradation
in the image quality and a reduction in the life of the consumables.
(b) Perform automatic calibration.
* Be sure to perform automatic calibration not only with the paper types adjusted in step (1) and (2),
but also all paper types. Refer to the following table for adjustment.
MFP mode How to perform automatic calibration
Copy
Perform step (1) referring to "To Obtain a Good Color Balance on
Thick Paper". Perform step (2) if required.
Print
(600dpi)
Print
(1200dpi)
Perform step (2) referring to "To Maintain a Steady Color Balance on
Thick Paper or Special Paper".
* After replacing any consumable, remember to reset the counter corresponding to it to "0." Otherwise, it
may cause a loss in MFP performance, including degradation in the image quality and a reduction in the
life of the consumables.
* While replacing any consumable, also check the slit glass in the laser optical unit, and thoroughly clean it,
if it is soiled.