Toshiba e-Studio Imaging 6520c - Manual (Page 15)

e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
1-5
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
1.2 To Adjust the Density on a Solid Colored Image
If the density is decreased If the density is increased
The solid colored area becomes lighter. The solid colored area becomes darker.
‰ Explanation
In thick paper printing, the density of a solid colored image can be made darker to enhance it or lighter in order
to match with the type or color of the original.
• The function described in this chapter cannot be used for plain paper 1 and 2 in the full color
mode.
The type of plain paper 1 and 2 is as follows.
Paper type not available Acceptable paper weight
Plain paper 1 64 to 80g/m² Max. 20 lb. Bond
Full color
Plain paper 2 81 to 105g/m² Max. 28 lb. Bond
Do not use the following code corresponding to plain paper 1 and 2 for the adjustment.
Paper type Color to adjust [08] code Subcode
Y (yellow) 0
M (magenta) 1
C (cyan) 2
Full color /
Black
Plain paper 1, 2
K (black)
08-2513
3
• When performing the adjustment in accordance with the procedure, note that the density of a
gradation area (halftone), such as a photograph, is adjusted as well as that of a solid colored
image.