Toshiba e-Studio Imaging 6520c - Manual (Page 23)

e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
1-13
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
(b) Enter the setting mode [08]. Change the value of the codes [5293/5294/5296] to adjust fusing
temperature in the recycled paper mode. (In this step fusing temperature is adjusted to print the
high-density area of the image most clearly.)
Adjustment
Paper
type
[08] code Subcode
Recommen
ded value
Accepta
ble value
range
Default
Black 0 10
Center heater
Color
Recycled
paper
08-5293
1
7 to 10 0 to 16
8
Black 0 10
Side heater
Color
Recycled
paper
08-5294
1
7 to 10 0 to 16
8
Black 0 3
Center
Color 1
1 to 6 0 to 16
1
Black 2 3
Pressure
roller
Side
Color
Recycled
paper
08-5296
3
1 to 6 0 to 16
1
• After adjusting the fusing temperature, perform automatic calibration.
* Refer to step (1) in "1.1 To Obtain a Darker Image".
The smaller the setting value, the lower the fusing temperature becomes. It is usually
recommended that the set value be decreased in order to suppress roughness on the high-density
area of the image. Adjust the value within the range of the recommended values while checking
the image carefully because if it is too small, insufficient fusing may occur.
Since temperatures on the long side of the paper cannot be kept in a proper balance, the same
value must be set for the [08] codes [5293] and [5294] unless otherwise required so.
After setting the value, print and check the image quality.
If further image quality adjustment is necessary, go to step (3).