Toshiba e-Studio Imaging 6520c User Manual

Page 20

e-STUDIO5520C/6520C/6530C

1-10

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)

1.3 To Achieve the Image Quality Most Suitable for the Paper Used

(To eliminate blur and graininess from an image)

Before the adjustment

After the adjustment

The image looks grained, depending on the
type of paper.

A clear image quality, most suitable for a type
of paper used, is obtained.

Explanation

The image sometimes looks slightly blurred or grained on the copy or printout, depending on the type of paper

used. Adjust the transfer roller bias output and the fuser temperature, in order to achieve the image quality most

suitable for the paper used.

Procedures

* All the steps in the adjustment must be performed by the service technician. The procedure to be followed

differs depending on the purpose as follows:

• To adjust halftone image: Go to step (1)

• To adjust images on the high-density area (only when recycled paper is used): Go to step

(1) Enter adjustment mode [05]. Change the values for codes [2934 to 3937] to adjust the transfer (2nd

transfer) roller bias output.

(Adjust the offset voltage of transfer roller bias so as to optimize the halftones.)

• The code to use varies depending on the paper type. Adjust the value for [05] code corresponding to the

paper type for which you would like to improve the image quality. Set the value within a range of "2" to

"8" to optimize the halftones.

This manual is related to the following products: