Toshiba e-Studio Imaging 6520c User Manual

Page 33

e-STUDIO5520C/6520C/6530C

1-23

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)

(5) Finely adjust the rotating speed of the registration motor, in accordance with a pattern for the out-of-

registration colors.

• Use steps (a) to (b) to perform the adjustment.

(a) Enter adjustment mode [05]. Select code [483]. Finely adjust the rotating speed of the registration

motor.

• Adjust the values in accordance with a pattern for the out-of-registration colors as shown in the

table below.

Pattern for

out-of-

registration

colors

[05] code

Subcode

Recommended value

Acceptable

value range

Default

Pattern A

123 to 127

(Set a value smaller than 128)

Pattern B

05-483 0

129 to 132

(Set a value larger than 128)

0 to 255

128

(b) After performing registration control, print out the test print pattern to check whether the misaligned

colors have been improved.

* For further information regarding the adjustment procedures, refer to procedures (3) and (4).

* Repeatedly use procedures (3) to (5) as necessary, to select a proper value.

When subcode "0" is adjusted for code 05-483, the correlation between the paper feeding speed

and rotating speed of the transfer belt will be corrected in every paper mode. However, when

colors are misaligned on an image printed in the thick paper mode after the adjustment for

subcode "0", adjust subcode "3" (during deceleration in the thick paper mode).

* For subcode "3," use the steps and recommended values for subcode "0."

* Paper for printing a test print pattern will only be fed from the drawer. Load the desired

number of sheets of thick paper in the drawer, in order to print the test print pattern on thick

paper.

* Adjust subcode "0" and then subcode "3," in order to adjust only misaligned colors in the thick

paper mode.

This manual is related to the following products: