Toshiba e-Studio Imaging 6520c User Manual

Page 30

e-STUDIO5520C/6520C/6530C

1-20

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)

Caution after the adjustment

• The adjustment may possibly slow down the copying or printing speed, extend the warm-up time when the

MFP is returned from the auto power save mode, and shorten the life of the consumables, because of an

increase in the number of times image quality control is performed. Therefore, carefully perform the

adjustment, while checking the copy or print image.

• Note the following when you print in thick paper mode in step (3):

• Printing speed decelerates to 17.5 sheets per minute (A4/LT) after the adjustment.

• The thick paper mode cannot be set for the LCF (Large Capacity Feeder, optional). Therefore the

maximum number of sheets acceptable for continuous printing should be the one for the drawer.

However in the copying mode, you can set the thick paper mode to more than one drawer and copy

more paper continuously with the automatic drawer change function.

• The density level of the halftone image may differ from that of the plain paper mode after the

adjustment.

• The PM counter value increases by 2 counts for 1 sheet of thick paper.

Remarks

• Enter the value mentioned in the procedures or one within the recommended value range for the adjustment.

Otherwise, it may cause a loss in MFP performance, including slowdown in the copying or printing speed.

• When replacing any consumable, refer to the relevant information in the Service Manual and Service Handbook.

This manual is related to the following products: