Toshiba e-Studio Imaging 6520c - Manual (Page 48)

e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-14
2. Copier-specific Adjustments
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
• Use steps (a) through (d) to perform the adjustment.
(a) Press the [IMAGE] button on the Control Panel.
(b) Press the [COLOR BALANCE] button to adjust the color balance by changing the amount of toner
(C, M, Y and K) or the [RGB ADJUSTMENT] button to adjust the color balance by changing the
intensity of R, G and B.
(c) Press the [+] button to enhance the tint of the color or the [-] button to decrease it.
* After selecting the color balance by changing the amount of toner (C, M, Y and K), press the
[DETAIL] button. The tint of the color can be adjusted according to density area (low-, medium-
or high-density area).
(d) Press the [ENTER] button.
After adjusting the tint of the colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(4) Enter adjustment mode [05]. Change the values for codes [1779 to 1798] to adjust the color density.
Color to
adjust
Original mode [05] code Subcode Recommended value
Acceptable
value range
Default
Text/Photo 05-1779 0/1/2
Text 05-1780 0/1/2
Printed image 05-1781 0/1/2
Photo 05-1782 0/1/2
Y
(Yellow)
Map 05-1783 0/1/2
Text/Photo 05-1784 0/1/2
Text 05-1785 0/1/2
Printed image 05-1786 0/1/2
Photo 05-1787 0/1/2
M
(Magenta)
Map 05-1788 0/1/2
Text/Photo 05-1789 0/1/2
Text 05-1790 0/1/2
Printed image 05-1791 0/1/2
Photo 05-1792 0/1/2
C
(Cyan)
Map 05-1793 0/1/2
Text/Photo 05-1794 0/1/2
Text 05-1795 0/1/2
Printed image 05-1796 0/1/2
Photo 05-1797 0/1/2
K
(Black)
Map 05-1798 0/1/2
Set a value larger than 128
to increase the density.
Set a value smaller than 128
to decrease the density.
0 to 255 128
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode Area where the density is adjusted
0 Low-density area
1 Medium-density area
2 High-density area