Toshiba e-Studio Imaging 6520c User Manual

Page 86

e-STUDIO5520C/6520C/6530C

2-52

2. Copier-specific Adjustments

2.11.2 To Adjust the Copy Image Quality of a Colored Logo

* You can start with any of the procedures. But it is recommended to perform the procedures in order, as listed

below. You can use one procedure in conjunction with another. But if this changes the image quality more

than required or loses the effectiveness of the adjustment, restore the settings made in the previously used

procedure to the original ones. Then use other procedures.

* Both the service technician and the user can use procedures (1) to (3).

* Only the service technician must use procedure (4).

(1) Press the [BASIC] button on the Control Panel. Press the [

] button to increase the copy density.

After increasing the copy density, copy and check the copy image quality.

With the copy density set to the maximum, if further image quality adjustments are still necessary, use the

next procedure.

(2) Perform color balance adjustment or RGB adjustment to adjust the tint of the colors in general.

• Use steps (a) through (d) to perform the adjustment.

(a) Press the [IMAGE] button on the Control Panel.

(b) Press the [COLOR BALANCE] button to adjust the color balance by changing the amount of toner

* After selecting the color balance by changing the amount of toner (C, M, Y and K), press the

[DETAIL] button. The tint of the color can be adjusted according to density area (low-, medium-

or high-density area).

(d) Press the [ENTER] button.

After adjusting the tint of the colors, copy and check the copy image quality.

If further image quality adjustments are still necessary, use the next procedure.

(3) Press the [BASIC] button on the Control Panel. Select "TEXT" from among the original mode options.

* To have "TEXT" selected from among the original mode options by default, refer to procedure (1) in 2.8

To Eliminate Moiré.

After selecting the Text or Map mode, copy and check the copy image quality.

If further image quality adjustments are still necessary, the service technician must use the next procedure.

This manual is related to the following products: