beautypg.com

Toshiba e-Studio Imaging 6520c User Manual

Page 22

background image

e-STUDIO5520C/6520C/6530C

© 2008 TOSHIBA TEC CORPORATION All rights reserved

1-12

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)

The transfer voltage increases as the set value is increased. It is usually desirable that the set

value be decreased to obtain a clearly highlighted area.


After performing the adjustment, print and check the image quality.

If further image quality adjustment is necessary, go to step (3).

(2) If the image on the high-density area looks grained on plain paper other than the TOSHIBA-recommended

one is used, select "recycled paper" as a paper type.

* To select the paper type, refer to the Operator’s Manual for Copying Guide.

• If fine adjustment of image quality in the recycled paper mode is required in accordance with the paper

type, follow the steps from (a) to (b) below.

(a) Enter the adjustment mode [05]. Change the value of the codes [2934] to [2937] to adjust (2nd)

transfer bias output. (In this step the transfer roller bias offset voltage is adjusted to print the high-

density area or the halftone area of the image most clearly.)

Paper type

[05] code

Subco

de

Recom

mended

value

Accepta

ble value

range

Default

Front

Recycled

paper

05-2934

7

2 to 8

0 to 10

5

Full color

Back

Recycled

paper

05-2935

7

2 to 8

0 to 10

5

Front

Recycled

paper

05-2936

7

2 to 8

0 to 10

5

Black

Back

Recycled

paper

05-2937

7

2 to 8

0 to 10

5

* "Front" refers to the printed side in the simplex mode or the side that is delivered facing

downwards in the duplex mode.

"Back" refers to the printed side that is delivered facing upwards in the duplex mode.

• After adjusting the transfer roller bias output, perform automatic calibration.

* Refer to step (1) in "1.1 To Obtain a Darker Image".

The larger the setting value is, the more the transfer voltage increases. It is usually

recommended that the set value be increased when you print on thick paper or paper with

asperities on its surface. On the other hand, the set value should be decreased when you print on

thin paper.


After setting the value, print and check the image quality.

If further image quality adjustment is necessary, go to step (b).

This manual is related to the following products: