19 to copy while erasing shadow outside of image – Toshiba e-Studio Imaging 6520c User Manual
Page 116
e-STUDIO5520C/6520C/6530C
© 2008 TOSHIBA TEC CORPORATION All rights reserved
2-82
2. Copier-specific Adjustments
2.19 To Copy While Erasing Shadow Outside of Image
Before the adjustment
After the adjustment
When originals such as books are copied, an
area outside of the image is copied like a
shadow because the original cover is not fully
closed.
The shadow is erased.
Explanation
When originals such as books are copied, an area outside of the image is copied like a shadow because the
original cover is not fully closed. Use the Outside Erase function to avoid copying areas outside of the image.
Procedures
* Both the service technician and the user can use all the steps of this adjustment.
(1) Press the [EDIT] tab on the touch panel and then press the [OUTSIDE ERASE] button.
Change the border between the original and areas not belonging to the original by pressing either [+] or [-]
as required.
* When you adjust it to [+] side, the area to be detected as that not belonging to the original is widened.
When you adjust it to [-] side, the area to be detected as that not belonging to the original is narrowed.
* When making copies in a bright room, leaving the RADF or the Platen Cover opened (The density of areas
not belonging to the original is lowered due to outside light.)
* When the original has extremely dark areas (The extremely dark areas are wrongly detected as areas not
belonging to the original and thus erased.)
* In case of special originals (e.g. a three-dimensional object, an original with black edges, the edges of an
opened book)
Caution after the adjustment
Areas not belonging to the original may not be erased exactly as the user has requested (erased too much or not
erased at all) depending on the type of the original. Also the area to be erased may change depending on the
orientation of the original. Therefore adjust it carefully while checking the copy image.