Ricoh Facsimile User Manual
Page 25
Polling Reception
15
1
❒ Polling Result Report allows you
to verify Polling Reception has tak-
en place. See p.16 “Polling Result
Report”. If E-mail TX Results is
programmed in a Quick Operation
key, you can select whether a re-
port e-mail is sent after reception.
The destination of this report can
be selected from the e-mail ad-
dresses in the destination list.
❒ You can program one of the Quick
Operation keys with operations for
this function. Using the key allows
you to omit step
A. See p.144 “Gen-
eral Settings/Adjustment”.
AAAA
Press [Transmission Mode].
BBBB
Press [Polling RX].
CCCC
Depending on which method you
are using, select one of the follow-
ing procedures:
Default ID/Free Polling Reception
A Check that [Default ID / Free Poll-
ing RX]
is selected, and then
press [OK].
Note
❒ To cancel Polling Reception,
press [Cancel]. The display
returns to that of step
B
.
ID Override Polling Reception
A Select [ID Override Polling Recep-
tion]
.
B Specify a 4-digit ID using the
number keys and [A], [B], [C],
[D], [E], and [F], and then press
[OK]
.
“ID Override: ” and the entered
Polling ID are shown above the
highlighted [Polling RX].
Note
❒ A Polling ID may be any four
numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.
❒ If you make a mistake, press
[Clear]
or the
{{{{Clear/Stop}}}} key
before pressing [OK], and
then try again.
❒ To cancel Polling Reception,
press [Cancel]. The display
returns to that of step
B
.
DDDD
Press [OK].
The standby display appears.
EEEE
Dial, and then press the
{{{{Start}}}}
key.
JupterC2_Fax_EN-F_FM.book Page 15 Monday, November 29, 2004 3:48 PM