Polling transmission clear report – Ricoh Facsimile User Manual

Page 23

Polling Transmission

EEEE

Press [Only Once] or [Save] to delete
or save the file after transmission.

Note

❒ To delete the original immedi-

ately after transmission, select
[Only Once]

❒ To repeatedly send the original,

select [Save].

❒ To cancel Polling Transmission,

press [Cancel]. The display re-
turns to that of step

FFFF

Press [OK].
“

pppppppppp” ap-

pears.
The type of Polling Transmission is
shown above the highlighted [Poll-
ing TX]

GGGG

Press [OK].

Note

❒ To check the settings, press

[Transmission Mode]

HHHH

Press the

{{{{Start}}}} key.

Note

❒ You can cancel the transmission

setup for Polling Transmission.
See p.19 “Canceling a Transmis-
sion”.

Polling Transmission Clear
Report

This report allows you to verify Poll-
ing Transmission has taken place.
If E-mail TX Results is programmed
in a Quick Operation key, you can
have the report e-mail sent after
transmission. See p.146 “Quick Oper-
ation Key”.

Limitation

❒ This report is not printed if the

User Parameters are set to allow
the stored originals to be repeated-
ly sent (Save). See p.166 “User Pa-
rameters” (switch 11, bit 7).

Note

❒ You can turn this function on or off

with the User Parameters. See
p.166 “User Parameters” (switch
03, bit 6).

❒ You can have a portion of the sent

image printed on the report with
the User Parameters. See p.166
“User Parameters” (switch 04, bit
7).

❒ You can check the result of Polling

Transmission with the Journal. See
p.27 “Printing the Journal”

❒ To view the report without text

disruption, select a font of even
character width in your e-mail ap-
plication's settings.

❒ You can display a destination with

the User Parameters. See p.166
“User Parameters” (switch 04, bit
4).

❒ You can indicate the receiving par-

ty's information with the User Pa-
r a m e t e r s . S e e p . 1 6 6 “ U s e r
Parameters” (switch 04, bit 5).

JupterC2_Fax_EN-F_FM.book Page 13 Monday, November 29, 2004 3:48 PM