Ricoh Facsimile - Manual (Page 115)

Where Incoming Message are Delivered - Output Tray
105
5
Where Incoming Message are Delivered -
Output Tray
Specifying Tray for Lines
The optional extra G3 interface unit is re-
quired.
You can specify the document feed-
ing tray for each port (telephone, In-
ternet Fax, IP-Fax). For example, you
can specify documents received
through the G3 -1 port to be fed to the
“Internal Tray 1” and documents re-
ceived through the G3 -2 port to be
fed to the “Internal Tray 2”, facilitat-
ing separation of files. You can also
set the machine to output Internet
Faxes and ordinary faxes onto differ-
ent trays.
Note
❒ To use this function, specify the
port and destination using [Specify
Tray for Lines]
. See p.147 “Reception
Settings”.
Tray Shift
The optional finisher is required.
When the optional finisher unit is se-
lected for fax output, you can use the
Tray Shift function whenever a fax or
report is printed.
This is useful for separating faxes
stacked in the finisher output tray.
For example, if the previous incoming
fax was output to the left, the next in-
coming fax will be output to the right
and vice-versa.
Note
❒ You can turn this function on or off
with the User Parameters. See
p.166 “User Parameters” (switch
19, bit 0).
JupterC2_Fax_EN-F_FM.book Page 105 Monday, November 29, 2004 3:48 PM