Step 11 – Nortel Networks 5500 series User Manual
Page 87
Configuring the domain
87
If you do not want to add a network access devices at this time,
press Enter to accept the default value (
no
). Go to
.
11
To add a network access devices, enter the required information
when prompted. For more information, see
switch setup wizard” (page 60)
.
Do you want to configure a switch?
(yes/no) [no]: yes
Enter the type of the switch (ERS8300/ERS5500)
[ERS8300]:
IP address of Switch:
NSNA communication port[5000]:
Red vlan id of Switch:
To continue, go to
.
12
Specify the action to be performed when an SRS rule check fails.
The options are:
•
restricted
—the session remains intact, but access is
restricted in accordance with the rights specified in the
access rules for the group
•
teardown
—the SSL session is torn down
The default is
restricted
.
In the event that the Nortel health Agent checks fails
on a client, the session can be teardown, or left in
restricted mode with limited access.
Which action do you want to use for Health Agent check
failure?
(teardown/restricted) [restricted]:
13
Specify whether you want to create a test local user (
nha
) in the
default
nhauser
group.
Do you want to create a test local user?
(yes/no)
[yes]:
If you do want to create a test user, press Enter to accept the
default value (
yes
). The wizard will create a test user named
nha
, with password
nha
, in the default
nhauser
group.
If you do not want to create a test user, enter
no
.
14
Specify whether you want to create a test user for system
authentication.
Do you want to create a test user for system
authentication?
(yes/no) [yes]:
15
Wait while the wizard completes processing to create the
domain, then enter
Apply
to activate the changes.
The wizard assigns the following default VLAN IDs:
•
Green VLAN = VLAN ID 110
•
Yellow VLAN = VLAN ID 120
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100
03.01
Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.