Nortel Networks 5500 series - Manual (Page 363)

Managing and maintaining the system 363
/boot
followed by:
The /boot/delete command is primarily intended for
when you want to delete a Nortel SNAS device in one
of the following situations :
•
The device has become isolated from the cluster,
•
The device has been physically removed from the
cluster without first performing the
/cfg/sys/host
#/delete command.
In these situations, you must use the /boot/delete
command to present the Setup menu, from which you
can perform the
new and join commands.
Managing software for a Nortel SNAS device
To view, download, and activate software versions for the Nortel SNAS
device to which you are connected, use the following command:
/boot/software
The Software Management menu appears.
The Software Management menu includes the following options:
/boot/software
followed by:
cur the status of the software versions on the particular
device to which are connected. The status options are:
•
permanent —the software version that is currently
operational
•
old —the software version that preceded the
currently operational software version
•
unpacked —the software upgrade package has
been downloaded but not yet activated
If you activate a software version indicated as either
unpacked or old , the status of that version is
propagated to permanent . The software status
change occurs after the Nortel SNAS device performs
a reboot.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.