Nortel Networks 5500 series - Manual (Page 481)

Supported traps 481
Table 89
Supported MIBs (cont’d.)
MIB Description
SNMP-USER-BASED-SM-MIB The following group is implemented:
•
usmMIBBasicGroup
Write access to all objects in this MIB is turned off in
VACM.
SNMPv2-MIB A standard MIB implemented by all agents. The following
groups are implemented:
•
snmpGroup
•
snmpSetGroup
•
systemGroup
•
snmpBasicNotificationsGroup
•
snmpCommunityGroup
SNMP-VIEW-BASED-ACM-MIB The following group is implemented:
•
vacmBasicGroup
Write access to all objects in this MIB is turned off in
VACM.
Supported traps
Table 90 "Supported traps" (page 481) describes the traps supported by
the Nortel SNAS.
Table 90
Supported traps
Trap Name Description
authenticationFailure Sent when the SNMP agent receives an SNMP message
which is not properly authenticated. This trap is disabled
by default. To enable the trap through SNMP, set
snmpEn
ableAuthenTraps to enabled or use the CLI command
/cfg/sys/adm/snmp/snmpv2-mib/snmpenable .
Defined in SNMPv2-MIB.
coldStart Sent when the Nortel SNAS reboots.
Defined in SNMPv2-MIB.
isdAlarmCleared Sent when an alarm is cleared.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.