Nortel Networks 5500 series - Manual (Page 456)

456 Syslog messages
About event messages
Events are sent at the NOTICE syslog level. Event messages are
formatted according to the following pattern:
Name:
Sender:
Extra:
Table 78 "System Control Process messages—EVENT" (page 456) lists
the System Control Process EVENT messages.
Table 78
System Control Process messages—EVENT
Message Category Explanation/Action
Name: partitioned_network
Sender and Extra is lower level
information. EVENT Indicates that a Nortel SNAS is
recovering from a partitioned network
situation.
Name: ssi_mipishere
Sender: ssi
Extra: EVENT Indicates that the Management IP
address (MIP) is now located at the
Nortel SNAS with the host IP
address.
Name: software_configuration_chang
ed
Sender: system
Extra: software release version
EVENT Indicates that release
(version) software status is
(unpacked/installed/permanent).
Name: software_release_copying
Sender:
Extra: copy software release
from other cluster member EVENT Indicates that is copying the
release from another cluster
member.
Name: software_release_rebooting
Sender:
Extra: reboot with release version
EVENT Indicates that a Nortel SNAS () is
rebooting on a new release (in other
words, a Nortel SNAS that was not
up and running during the normal
installation is now catching up).
Name: audit
Sender: CLI
Extra: Start EVENT Sent when a CLI system administrator
enters, exits, or updates the CLI
if audit logging is enabled using
the
/cfg/sys/adm/audit/ena
command.
Name: license_expired
Sender = EVENT Indicates that the demo license
loaded to host has expired.
Check the loaded licenses with
/cfg/sys/cur .
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.