Nortel Networks 5500 series - Manual (Page 324)

324 Configuring SNMP
Configuring SNMP
To configure SNMP for the Nortel SNAS network, access the SNMP menu
by using the following command:
/cfg/sys/adm/snmp
From the SNMP menu, you can configure and manage the following:
• general settings for SNMP management of the cluster (see
“Configuring SNMP settings” (page 325) )
• parameters in the standard SNMPv2 MIB (see “Configuring the SNMP
v2 MIB” (page 326) )
•
monitor, control, and trap community names (see “Configuring the
SNMP community” (page 327) )
•
SNMPv3 users (see “Configuring SNMPv3 users” (page 328) )
• SNMP managers (see “Configuring SNMP notification targets” (page
331) )
• SNMP monitors and events (see “Configuring SNMP events” (page
332) )
Roadmap of SNMP commands
The following roadmap lists the CLI commands to configure SNMP. Use
this list as a quick reference or click on any entry for more information:
Command Parameter
/cfg/sys/adm/snmp ena
dis
versions
/cfg/sys/adm/snmp/snmpv2-mib sysContact
snmpEnable disabled | enabled
/cfg/sys/adm/snmp/community/cfg/sys
/adm/snmp/community
read
write
trap
/cfg/sys/adm/snmp/users name
seclevel none | auth | priv
permission get | set | trap
authproto md5 | sha
authpasswd
privproto des | aes
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.