Nortel Networks 5500 series - Manual (Page 74)

74 Managing the network access devices
/cfg/domain #/switch #/hlthchk
followed by:
deadcnt Specifies the number of times the Nortel SNAS
will repeat the check for switch activity when
no heartbeat is detected.
•
count is an integer in the range 1–65535
that indicates the number of retries. The
default is 3.
If no heartbeat is detected after the specified
number of retries, the Nortel SNAS enters
status-quo mode.
sq-int Sets the time interval for status-quo mode,
after which the network access devices moves
all clients into the Red VLAN.
•
interval is an integer that indicates the
time interval in seconds ( s ), minutes ( m ), or
hours ( h ). The valid range is 0 to 64800s
(18h). The default is 1m (1 minute).
Controlling communication with the network access devices
To stop communication between the Nortel SNAS and a network access
devices, use the following command:
/cfg/domain #/switch #/dis
Enter apply to apply the change immediately.
ATTENTION
If the switch is not going to be used in the Nortel SNAS network, Nortel
recommends deleting the switch from the Nortel SNAS domain, rather than just
disabling it.
To restart communication between the Nortel SNAS and a network access
devices, use the following command:
/cfg/domain #/switch #/ena
Enter apply to apply the change immediately.
Configuring SSCPLite
SSCPLite is a SNAS enforcement protocol that uses SNMP to restrict a
users network access using dynamically provisioned VLAN’s based on
users credentials and device health assessment. SSCPLite supports
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.