Nortel Networks 5500 series - Manual (Page 40)

40 Overview
5 Perform the initial setup on the Nortel SNAS (see “Initial setup”
(page 43) ). Nortel recommends running the quick setup wizard
during initial setup, in order to create and configure basic
settings for a fully functional portal.
6 Enable SSH and SRS Admin to allow communication with the
SREM (see
“Configuring administrative settings” (page 281) ).
7 Generate and activate the SSH key for communication
between the Nortel SNAS and the network access devices (see
“Managing SSH keys” (page 68) ).
8 Specify the Software Requirement Set (SRS) rule for the default
nhauser group (see “Configuring groups” (page 156) ).
9 Add the network access devices and export the SSH key (see
“Adding a network access devices ” (page 60) ).
10 Specify the VLAN mappings (see “Mapping the VLANs” (page
66) ).
11 Test Nortel SNAS connectivity by using the /maint/chkcfg
command (see “Performing maintenance” (page 353) ).
12 Configure groups (see “Configuring groups and profiles” (page
149) ).
13 Configure client filters (see “Configuring client filters” (page
162) ).
14 Configure extended profiles (see “Configuring extended profiles”
(page 164) ).
15 Specify the authentication mechanisms (see “Configuring
authentication” (page 171) ).
16 Configure system users (see “Managing system users and
groups” (page 211) ).
17 Configure the end user experience (see “Customizing the portal
and user logon” (page 227) ).
--End--
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.