Nortel Networks 5500 series - Manual (Page 282)

282 Configuring system settings
/cfg/sys/adm
followed by:
snmp Accesses the SNMP menu, in order to
configure network management of the cluster
(see ).
sonmp on|off Enables or disables support for SynOptics
Network Management Protocol (SONMP)
network topology information. The default is
disabled (
off ).
clitimeout Sets the timeout interval for user inactivity
in the CLI. At the end of the timeout
period, if there is still no activity, the user is
automatically logged out.
•
interval is an integer that indicates the
time interval in seconds ( s ), minutes ( m ),
hours ( h ), or days ( d ). If you do not specify
a measurement unit, seconds is assumed.
The range is 300–604800 seconds (5 m–7
d). The default is 600 (10 m).
Changes to the timeout value do not take
effect until the next logon.
When the user is automatically logged out,
any unapplied changes are lost. Save your
configuration changes regularly by using the
global
apply command.
audit Accesses the Audit menu, in order to
configure RADIUS auditing (see
“Configuring
RADIUS auditing” (page 286) ).
auth Accesses the Authentication menu, in order
to configure RADIUS authentication of system
users (see
“Configuring authentication of
system users” (page 290) ).
abl Accesses the Auto Blacklisting menu.
hardenpass Accesses the Harden Password menu.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.