Nortel Networks 5500 series - Manual (Page 293)

Configuring the cluster 293
/cfg/sys/adm/auth/servers
followed by:
add Adds a RADIUS authentication server to the
configuration. You are prompted to enter the
following information:
•
IPaddr —the IP address of the
authentication server
•
port —the TCP port number used for
RADIUS authentication. The default is
1813.
•
shared secret —the password used
to authenticate the Nortel SNAS to the
authentication server
The system automatically assigns the next
available index number to the server.
insert Inserts a server at a particular position in the
list of RADIUS authentication servers in the
configuration.
•
index number —the index number you
want the server to have
•
IPaddr —the IP address of the
authentication server you are adding
The index number you specify must be in use.
The index numbers of existing servers with this
index number and higher are incremented by
1.
move
index number>
Moves a server up or down the list of RADIUS
authentication servers in the configuration.
•
index number —the original index number
of the server you want to move
•
new index number —the index number
representing the new position of the server
in the list
The index numbers of the remaining entries
adjust accordingly.
Configuration of auto blacklisting
To create the auto blacklisting, use the following command:
cfg/sys/adm/abl
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.