Nortel Networks BCM1000 - Manual (Page 40)

40 BCM1000, BCM 3.0 addendum
Installation and Maintenance Guide P0607659 02
Initializing the hard disk (single-disk system)
The BCM1000 is normally initialized at the factory. However, if you have to replace the hard drive in a single-disk
BCM1000, you must re-initialize the Business Communications Manager.
After you replace the hard disk and the system has booted up, perform the initialization as follows:
1. Enter the terminal emulation program, as described in Finding the configuration menus on page 170.
The Platform Initialization Menu appears. Refer to Figure 8.
Figure 8 Platform Initialization Menu screen
2. Enter 1 (Initialize Menu) and press .
The Initialize Menu appears. Refer to Figure 9.
1-800-4 NORTEL
www.nortelnetworks.com
P0993298 02