Nortel Networks BCM1000 - Manual (Page 11)

11
Installation and Maintenance Guide
International Regulatory Information
This is a class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Hereby, Nortel Networks declares that Enterprise Edge/Business Communications Manager
Model No. NT7B10xxxx, is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
Information is subject to change without notice. Nortel Networks reserves the right to make
changes in design or components as progress in engineering and manufacturing may warrant. This
equipment has been tested and found to comply with the European Safety requirements EN 60950
and EMC requirements EN 55022 (Class A) and EN 55024. These EMC limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a
commercial and light industrial environment.
Safety
The CE Marking on this equipment indicates compliance with
the following:
This device conforms to Directive 1999/5/EC on Radio
Equipment and Telecommunications Terminal Equipment as
adopted by the European Parliament And Of The Council.
WARNING
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures. The
above warning is inserted for regulatory reasons. If any customer believes that they have
an interference problem, either because their Nortel Networks product seems to cause
interference or suffers from interference, they should contact their distributor immediately.
The distributor will assist with a remedy for any problems and, if necessary, will have full
support from Nortel Networks.
WARNING!
Only qualified service personnel may install this equipment. The instructions in this
manual are intended for use by qualified service personnel only.
Risk of shock.
Ensure the Business Communications Manager base unit is unplugged from the power
socket and that any telephone or network cables are unplugged before opening the
Business Communications Manager base unit.
Read and follow installation instructions carefully