Nortel Networks BCM1000 - Manual (Page 39)

BCM1000, BCM 3.0 addendum 39
P0607659 02 Installation and Maintenance Guide
Upgrading from a standard system
When you upgrade your BCM1000 from a single power supply and fan to a redundant system, you need to remove
the jumper from the connectors on the System Status Monitor board to allow the cables from the redundant
equipment to be connected.
The diagram below notes the location of the connectors for the redundant power supply and for the redundant fan.
Figure 7 System Status Monitor internal connectors
SSM board
J7 J6
Mother board Redundant power supply
monitoring cable
Mother board (J10)
Board power
Redundant/primary fans
CPU fan Remote temperature
sensor
Note: Chassis has all PCI
cards removed, for clarity